Our new PPM encoder allows you to connect your PWM-only RC equipment
to PPM-only autopilot systems, like Pixhawk. Smaller than our previous
PPM, our encoder will enable you to reduce all your channels to a single
wire, excluding ground and power wires. As a result, you’ll get faster
processing and reduced points of error.
3DR PPM encoder includes
- PPM encoder module
- PPM input cable to PWM receiver DF13 10-position to servo (7 cm)
- PPM output cable to autopilot DF13 three-position to servo (12 cm)
Documentation and User Guides
- ATmega 328 p microcontroller, firmware upgradeable via an AVRISP programmer
- 22 x 19 x 5.5 mm (without cables)
- 1.45 g
| Learn more about open-source hardware
Released under the Creative Commons Attribution Share-Alike 4.0 International License
Designed by 3D Robotics Inc.